Connect Serial ATA devices to your motherboard or host controller; for transfer rates up to 6G
(1) SATA 7-pin Male
(1) SATA 7-pin Male
When connecting serial ATA devices to your motherboard or host controller, you want a permanent solution. The last thing you need is a cable that could fatigue, or even fail over time, because of bending or stress occurring right at the critical connection. Our angled connectors deliver the cable at a more desired angle and are fortified to keep the cable lined up straight. So you'll see less cable bend and fatigue for longer cable life.
SATA 3.0 compatible with transfer rates up to 6 Gbps! This serial ATA cable is especially designed to handle the differential signals implemented in today's technology, while delivering increased throughput and reduced data packet loss.
With our 7-pin, 1-device cable, you'll receive higher data transmission rates, reduced crosstalk, and improved signal integrity.
Plus, this cable reduces overheating and saves internal space within the CPU unit for easy movement when adding or removing hard drives, PCI cards or other adapters. Our serial ATA cable can minimize clutter, increase airflow and maximize your potential transfer rate.
Rated 3 out of 5 by Matt from Check your motherboard connectionCheck your motherboard and verfiy that the "key" is in the correct position. I would have liked to use these cables as they look slick, but my motherboard is configured as such that they would point down instead of up. Too bad. I did not purchase, and can't until they offer right angle with either "key". Otherwise seems to be a nice product.
Date published: 2010-01-26
Rated 5 out of 5 by Mike from A life saver!Needed a cable that comes off to the left of the drive so my cable management would come off without a hitch. This worked perfectly! Yes, it does cover the power connector, so if your power cable comes straight off the drive it won't work, but if you have a cable with 90 degree connectors (so the wire comes off the top or bottom of the drive) this works just fine. I only wish this came in black and that it had a locking clip.
Date published: 2012-08-08
Rated 4 out of 5 by DAVID from GOOD PRODUCT, WOULD BUY AGAIN!!A MUST FOR SATA DRIVES NATURALLY, SATISFY ALL MY NEEDS-ESPECIALLY PRICE!!
Date published: 2009-10-13
Rated 3 out of 5 by John from Side Connector not for hard driveI purchased 2 of these cables to improve airflow in the hard drive cage of my case. Unfortunately, the connector, if plugged into the back of a hard drive, points to the left and blocks the power connector. So the side connector is only useful if plugged into a motherboard. The picture from Cables-to-Go does not show this. You can't see the socket pattern on the side-pointing connector.
Date published: 2009-06-10
Rated 5 out of 5 by Lady Fitzgerald from @ John from AlbanyActually, the fourth photo clearly shows the socket pattern on the side-pointing connector (I wouldn't have bought it if it didn't). A right angle power connector will clear the right angle SATA connector with room to spare.
Date published: 2012-08-04
Rated 5 out of 5 by STO from Works as advertisedWorks as advertised